So we just bought some new screens. 230s since we had been using 305s and were having too many problems, and we were told that it was too high of a mesh, etc.
So we coated these new screens that same way we had been and exposed for the same amount of time as usual.... and we lost a good amount of the artwork during the rinsing phase - things just completely blew out... could it be that we should have abraded these new screens?? I just did some searching on here and read that on a few threads about this and was never aware of this.
Also, can anyone suggest a good degreaser?? I hear a lot of people use Simple Green??? Does this work well?? Where can you buy this?? Any other suggestions?? We are using Ulano TZ with Speedball Permanent Poster Inks.
Thanks in advance!!