We decided to build a new LARGE FORMAT vacuum pres this past Sunday.. here are some step by step photos:
1. Built the legs/support for the table top.
2. Piece of that sawdust board with plastic whit coating on top will be the print surface.
3. Laying down the grid for all the air holes.. every half an inch.
4. My biz partner Marty begins drilling.. 1/16 inch holes.. every half inch.
Note: we drilled 8,000 holes in about 4 hours w/ 2 drills. FUCKING SUCKS TO DO THAT!
5. Close up of holes.
Ill post the rest of the complete project later...