This question goes out to Andy (or anyone else who can assist):
So, I'm gathering the materials to build the Vacuum Table featured in the book Screen Printing Today.
For the perimeter it says to cut 2 spacers that are 24" x 3" and another 2 that are 16 1/4" x 3".
When laying them out, the 24" sides line up fine, but the 16 1/4" spacers leave a gap on each side. Is that right?
I know one side should have a gap for the vacuum nozzle.
To add to my confusion, in Step 3, it refers to the 16 1/4" spacers as 16 1/2".
Are these errors or am I not reading these instructions correctly?