hey everyone. so i'm in the process of setting up my garage screen printing shop. i have never done any plumbing in my life and i figured that you guys would know what you're doing and give me some pointers so i dont fuck up and flood my house and piss off my 4 roomates...
i have a space in the laundry area where i can put the sink, but the faucet comes out from the wall, and the drain pipes are under the faucet. if i were to build or install a washout sink i would need to put the back of the sink in front of the faucet which would make the drain hole not match up to the drain pipe. so how would i connect these without getting any leakage? my current laundry sink has a drain that goes out like a screw and screws into the drain pipe to fit.
the laundry sink is not even two feet wide so i need to completely replace it instead of adding on to it. the actual faucet spout can be removed and i'm going to put the double ended hose connector on it instead.
here are some pics
any advice would be so much appreciated!
also.......where do you find shower board or anything similar to build the sink walls out of? i looked at home depot and couln't find anything. thanks






LinkBack URL
About LinkBacks



Reply With Quote
